4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 6-17
Transport Error Set Continuity Count
Error
Cause: Possible uplink or
signal issue.
Remedy: Clear warnings,
reset the unit, and notify
customer service if the
problem persists.
Transport packet
continuity count
jumped. Possible
packet loss.
Buffer Overflow The transport stream
is faster than the
maximum buffer or
the decode engines
are having difficulty
handling the data
sent to them.
Transport Error
Indicator
Transport packets are
marked as "errored"
upstream of the
decoder.
Transport Rate Error:
FPGA Overflow
Cause: Uplink settings may
have changed since setting
up the unit.
Remedy: Increase the
output rate, drop
unreferenced content in
DPM Options, and/or drop
programs not needed for
downstream devices.
Contact your (uplink)
service provider to verify
the expected bit rate
settings.
The output rate is
higher than level set
by the user.
Clear Continuity Count
Error Cleared
Trap expires after 30
seconds.
Buffer Overflow
Cleared
Transport Error
Indicator Cleared
Transport Rate Error:
FPGA Overflow
Cleared
CI Status Set Different CA Systems
in Top/Bottom Slots
Cause: Different CA
systems are used in the
slots.
Remedy: Replace the CA
cards to use the same CA
system.
Different CA Systems
in Top/Bottom slots.
Clear OK
Video Format
Mismatch
Set Video format
mismatch
Video Format
Mismatch.
Clear Video format match
Warning Message
Type
Message Cause/Remedy Description
To Next Page
Loading...
Need help?
General
