Cisco D9854 User Manual

4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 6-19
PMT timeout # Set pmt # timed out Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning. If
the problem persists,
determine if uplink is
sending the current SI
information table. Disable
the warning if not using the
table.
Program Mapping
Table was never
received.
pmt # is lost No longer receiving
Program Mapping
Table.
Clear pmt fault cleared
PAT timeout # Set pat # timed out Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning. If
the problem persists,
determine if uplink is
sending the current SI
information table. Disable
the warning if not using the
table.
Program Association
Table was never
received.
pat # is lost No longer receiving
Program Association
Table.
Clear pat fault cleared
NIT timeout # Set nit timed out Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning. If
the problem persists,
determine if uplink is
sending the current SI
information table. Disable
the warning if not using the
table.
Network Information
Table was never
received.
nit is lost No longer receiving
Network Information
Table.
Clear nit fault cleared
CAT timeout # Set cat timed out Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning. If
the problem persists,
determine if uplink is
sending the current SI
information table. Disable
the warning if not using the
table.
Conditional Access
Table was never
received.
cat is lost No longer receiving
Conditional Access
Table.
Clear cat fault cleared
Warning Message
Type
Message Cause/Remedy Description

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C