Contents
xii
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
CHAPTER
14 Configuring MLS 14-1
Understanding How Layer 3 Switching Works 14-1
Understanding Layer 3-Switched Packet Rewrite 14-2
Understanding MLS 14-4
Default MLS Configuration 14-12
Configuration Guidelines and Restrictions 14-13
IP MLS 14-13
IP MMLS 14-14
IPX MLS 14-15
Configuring MLS 14-16
Configuring Unicast MLS on the MSFC 14-16
Configuring MLS on Supervisor Engine 1 14-19
Configuring IP MMLS 14-31
CHAPTER
15 Configuring Access Control 15-1
Understanding How ACLs Work 15-2
Hardware Requirements 15-2
Supported ACLs 15-3
QoS ACLs 15-3
Cisco IOS ACLs 15-3
VACLs 15-4
Applying Cisco IOS ACLs and VACLs on VLANs 15-7
Bridged Packets 15-7
Routed Packets 15-8
Multicast Packets 15-8
Using Cisco IOS ACLs in your Network 15-9
Hardware and Software Handling of Cisco IOS ACLs with PFC 15-10
Hardware and Software Handling of Cisco IOS ACLs with PFC2 and PFC3A/PFC3B/PFC3BXL 15-13
Using VACLs with Cisco IOS ACLs 15-17
Configuring Cisco IOS ACLs and VACLs on the Same VLAN Interface Guidelines 15-17
Layer 4 Operations Configuration Guidelines 15-23
Using VACLs in Your Network 15-25
Wiring Closet Configuration 15-26
Redirecting Broadcast Traffic to a Specific Server Port 15-26
Restricting the DHCP Response for a Specific Server 15-27
Denying Access to a Server on Another VLAN 15-28
Restricting ARP Traffic 15-29
Inspecting ARP Traffic 15-30
To Next Page
Loading...
