Comtec CDM-840 - Page 193

CDM-840 Remote Router MN-CDM840
Serial-based Remote Product Management Revision 3
7–25
Parameter
Type
Command
(Instruction
Code
& Qualifier)
Number of
Arguments for
Command or
Response to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code &
Qualifier)
Response to Query
(Target to Controller)
Adjustment
for Internal
10MHz High-
stability
Reference
ADJ=
4 bytes
Command or Query.
Sets or returns the fine adjustment of the Internal 10MHz Reference on the
High-Stability Frequency Reference module in the form sddd, where:
s=sign [– (negative) or + (positive)]
ddd=value from 0 to 999.
EXAMPLE: <0/ADJ=-123[cr]
ADJ=
ADJ?
ADJ*
ADJ#
ADJ?
ADJ=sddd
(see Description of
Arguments)
Circuit ID
String
CID=
4 to 32 bytes
Command or Query.
Sets or returns the user-defined Circuit ID string, which is 4 to 32 characters in
length.
NOTE: Valid characters include Space ( ) * + – , . / 0 thru 9 and A thru Z
EXAMPLE: <0/CID=RxCircuitID[cr]
CID=
CID?
CID*
CID#
CID?
CID=x [4..32]
(see Description of
Arguments)
Default
Password
DPW=
N/A
Command only.
NOTE: THIS COMMAND TAKES NO ARGUMENTS.
Resets the admin username/password to:
Username=“comtech”
Password=“comtech”
DPW=
DPW?
DPW*
DPW#
N/A
N/A
Firmware
information
N/A
100 bytes
Query only.
Returns firmware information for Image 0, 1 or 2, where:
0=Bootrom Information
1=Image #1 Firmware Information
2=Image #2 Firmware Information
The information return in the form xxxxx…,mm/dd/yy where:
xxxxx…=The firmware number
mm/dd/yy=The firmware date in month/date/year
EXAMPLE: <0/FRW?1[cr]
N/A
FRW?0
FRW?1
FRW?2
FRW=xxxxx…,mm/dd/yy
(see Description of
Arguments)
Geographical
Log
Information
GLG=
18 bytes
Command only.
Sets the geographical log information in the form
AAAAOOOOOXNNNNNNNN, where:
AAAA=Latitude
OOOOO=Longitude
X=exclusion zone status (0 or 1)
NNNNNNNN=name of satellite used
NOTE: Data is stored in the file “GPS.log.” Data in the log file older than one
year is removed from the log file. The format of the text in the log file is a
single GLG command per line:
WWWWSSSSSSSSFFFFFFFFBBBBBBBBMAAAAOOOOONNNNNNNN,
where:
GLG=
GLG?
N/A
GLG=AAAAOOOOOXN
NNNNNNN
(see Description of
Arguments)