128 • SMP Gateway User Manual
16.2 Setting Up the Annunciator
The Annunciator’s configuration is stored in the SMP Gateway’s configuration file, which is
edited using SMP Config.
In SMP Manager, select your SMP Gateway.
From the Tools menu, select SMP Config.
SMP Config opens, displaying the current configuration of your SMP Gateway.
You must create the Annunciator instance before you can configure it. Proceed as follows:
In SMP Config, from the tree view, select Annunciator.
In the Annunciator Instance pane on the right, type a name for the Annunciator.
Click again the Annunciator branch to create the instance.
Expand the newly created branch. The resulting tree view should resemble the one that is
displayed in the following illustration.
To configure the Annunciator, you must go through the following steps:
Configure alarm inputs.
Set up display pages.
Create user-defined readings pages, if you like.
Select which pages will be available for display, and which one will be displayed at startup.
You can also:
To Next Page
Loading...
