Cooper SMP 4 - R Command

242 • SMP Gateway User Manual
If you have setup a firewall using a previous version of the SMP Gateway software, you can still
use Firewall Manager to set up rules. However, these rules will be overridden if you set up a
firewall instance using SMP Config (see “Configuring the Firewall”, page 104).
Not
e: To use Firewall Manager, the user must have the System Management privilege
for the SMP Gateway.
To use Firewall Manager, proceed as follows:
 In the Telnet window, type the following command at the prompt:
firewallmgr
Firewall Manager displays the list of available commands, as the following shows:
Firewall Manager.
Available commands (case insensitive):
Note: Use "SMP Config" to change the firewall configuration.
R Show custom firewall rules.
S Show the current firewall and VPN status.
H Display the list of available commands.
Q Quit.
The commands are described in the following sections.
27.2.1 R Command
The R command displays the list of firewall rules you have set-up.
27.2.2 S Command
The S command shows the current status of the firewall and VPN connections.
Example:
Firewall: disable
Firewall log: enable
VPN connections: 2
27.2.3 H Command
The H command displays the list of available commands, as shown at the beginning of this section.