Cooper SMP 4 - Q Command

SMP Gateway User Manual • 243
27.2.4 Q Command
The Q command is used to exit the firewall manager.
27.3 Time and Date
You can now set the SMP Gateway’s date and time using SMP Manager, as described in the
“Setting SMP Gateway’s Internal Clock” section, page 195.But the Time and Dat
e Telnet
commands are still available for that matter.To set the SMP Gateway’s time:
 In the Telnet window, type the following command at the prompt:
time
The current UTC time is displayed, followed by a prompt for the new time. For example:
The current time is: 3:22:40 PM
Enter the new time (hh:mm:ss):
 Type the new UTC time in the requested format and press ENTER.
To set the SMP Gateway’s date:
 In the Telnet window, type the following command at the prompt:
date
The current time is displayed, followed by a prompt for the new time. For example:
The current date is: Tuesday, June 10, 2008
Enter the new date (mm-dd-[yy]yy):
 Type the new date in the requested format (year can be specified using two digits) and press
ENTER.
Note: For both commands, the time/data will remain unchanged if you do not type
anything and press ENTER.
27.4 Clock Manager
Clock Manager was used for time adjustment setup. It has been replaced by SMP Config since
version 4 of the SMP Gateway Software & Tools. It is now mainly used to get an overview of the
GPS clock settings; for more details, refer to the SMP 16 GPS clock option installation manual.