Cooper SMP 4 - D Command

244 • SMP Gateway User Manual
To use Clock Manager, proceed as follows:
 In the Telnet window, type the following command at the prompt:
clockmgr
Clock Manager displays the list of available commands, as the following shows:
Clock Manager.
Available commands (case insensitive):
Note: Use "SMP Config" to change the clock configuration.
D Display the current settings.
H Display the list of available commands.
Q Quit.
The commands are described in the following sections.
27.4.1 D Command
The D command shows the current settings of the optional GPS clock.
Example:
GPS Cable length: 0 m
IRIG-B distribution format for the GPS: IRIG-BXX0 IEEE 1344
Always distribute the IRIG-B signal: No
27.4.2 H Command
The H command displays the list of available commands, as shown at the beginning of this section.
27.4.3 Q Command
The Q command is used to exit the clock manager.
27.5 Elo Touchscreen Driver Manager
If you use a touch screen with your SMP Gateway, you may no longer be able to reset the
calibration settings via the touch screen itself. At runtime, you can use the Elo Touchscreen Driver
Manager for this matter.
To enter touch screen calibration mode, proceed as follows: