SMP Gateway User Manual • 125
16 Using the Annunciator
Interface
The SMP Gateway’s Annunciator option is a cost-effective solution that provides a local HMI for
substation operators. Using SMP Config, you can set up alarms based on the analog and binary
data points of your SMP Gateway, and design simple pages to display the current statuses and
values of these points and alarms on a touch screen, which also allows you to handle the alarms
and perform control operations.
Note: The Annunciator option is only available for the SMP 16/CP and SMP 16/SG.
With the Annunciator option, you can:
monitor a list of all active alarms, as well as alarms that have returned to normal but have not
been acknowledged yet;
acknowledge, block and clear alarms;
consult an history log of recent alarms and operations on alarms;
access some of the SMP Gateway’s internal statistics;
monitor real-time values of the SMP Gateway’s data points through user-defined and highly
customizable readings pages;
perform control operations on your SMP Gateway on site, just like you would from the
SCADA.
An example of the Annunciator’s display is presented on next page. In this example, we see a
readings page that has been designed to display the simplified single-line diagram of a feeder.
To Next Page
Loading...
