Cooper SMP 4 - Setting Up the System State Page

SMP Gateway User Manual • 137
 You can also use the preview section of the edition pane to modify the columns’ width, order
and availability state, like for the Alarms page (see “Setting Up the Alarms Page”, above).
 The messages list can be filtered by the operator at runtime to display only alarm or operation
messages, using touch buttons. To display these buttons in the History page, select the Show
display types buttons checkbox.
The messages list can hold a limited number of messages, which is called the history length. To
adjust this setting:
 In SMP Config's tree view, under the Annunciator instance, select the General branch.
 Under History Length, specify the maximum number of alarm messages that will be
preserved in the history log.
16.2.5 Setting Up the System State Page
Various system information and statistics about the SMP Gateway and the Annunciator can be
displayed in the System State page.
To learn how to use this page, see “Monitoring System Status”, page 157.
To sel
ect which information should be displayed and how, proceed as follows:
 In SMP Config, from the tree view, expand the Pages branch and select the System State
branch. The resulting content of the right pane is presented in the following screenshot.