194 • SMP Gateway User Manual
Start a Telnet session:
From the Tools menu, click Telnet.
In the Telnet window that appears, type the following command:
snmpmgr
SNMP manager lists all available commands, as shown next:
\> snmpgr
SNMP Manager
Available commands (case insensitive):
A Add a client.
R Remove a client.
L Display all clients.
M Modify the community membership of a client.
C Change a client description.
G Add a community.
D Remove a community.
B Display all communities and their permissions.
I Modify the permissions of a community.
T Modify the name of the system contact.
O Modify the location of the gateway on which the agent is running.
F List information on system contact and gateway location.
W Modify the firewall settings.
H Display the list of all commands.
esc Abort the current operation.
Q Quit.
You can display the previous list any time, by using the “H” command.
You should specify the SNMP settings in the following order:
Add communities and their permissions.
Add a system contact.
Add a system location.
Add a number of clients and associate them to communities.
Any modifications you make will go into effect the next time the SMP Gateway will restart.
To Next Page
Loading...
