SMP Gateway User Manual • 255
Proceed as follow:
Connect your PC to the SMP Gateway’s console port using an RS-232 serial cable.
Start a terminal application such as HyperTerminal. Configure the communications settings to
use the serial port connected to the SMP Gateway. Set the port speed to 115,200 bps.
Restart the SMP Gateway. Wait for the following prompt to appear in the terminal
application’s window:
********************************************
Press ENTER now to access configuration mode
********************************************
The SMP Gateway will start in 2 seconds...
Press ENTER. The following menu will appear:
Current GMT time: 2008/06/10 18:16:53
Available commands:
S Set the clock
C Configure TCP/IP parameters
U Update the firmware
F Reset the SMP Gateway configuration to the factory default
M Start the SMP Gateway in MAX SAFE MODE
W Start the SMP Gateway
Note. The SMP Gateway will start after 60 seconds if you have not
pressed any
key.
>
Press F to reset the SMP Gateway configuration to the factory default.
Type yes to confirm your selection. The SMP Gateway will restart and the firewall should no
longer be enabled on it.
To Previous Page
Loading...
