doubt, contact your state and local environmental authorities or the Environmental Protection Agency for
guidance as to proper handling and disposal of used engine oil and coolant/antifreeze.
• The CELECT™ injector solenoids receive high voltage when the engine is operating. Do not touch the injector
solenoids or the solenoid wires when the engine is operating. This can result in electrical shock.
•Donot connect jumper starting or battery charging cables to any CELECTY part. This can damage the
CELECT™ parts.
• To protect the ECM computer circuits, it is mandatory to remove all connectors going to the ECM. Disconnect
both the positive (+) and negative (-) battery cables from the battery before welding on the vehicle. Attach
the welder ground cables as close as possible to the part being welded. Do not connect the ground cable of
the welder to the cooling plate or ECM.
Section i - Introduction General Safety Instructions
N14 Page i-9
To Next Page
Loading...
