Remove the coolant inlet transfer connection from the
water pump.
Remove the six mounting capscrews from the water
pump.
NOTE: The water pump must be removed carefully to pre-
vent damage to the impeller.
Remove the water pump from the engine.
Remove the water pump out and in a downward direction
to clear the dowel pin and disconnect the water transfer
tube attached to the thermostat housing.
Clean the water pump gasket surface on the cylinder
block.
Installation
Caution: The water pump must have a dowel pin locat-
ing hole and oil cooler return passage. Engine damage
will occur due to lack of coolant flow through the oil
cooler.
Water Pump (1-27) Section 1 - Cooling System
N14Page 1-60
To Next Page
Loading...
