Cleaning and Inspection
Use a 240 grit emery cloth to remove carbon deposits
from the sealing surfaces.
Steam clean, and dry with compressed air.
Visually inspect for cracks or damage.
Visually inspect the manifold seal bore for wear.
Installation
Install the exhaust manifold end sections to the center
section.
NOTE: The exhaust manifold sections must be assembled
on a flat surface for proper alignment.
Install two guide studs.
Use an adhesive or heavy grease to hold the gaskets in
place on the cylinder head.
NOTE: The side of the gasket marked ‘‘OUT’’ must be away
from the cylinder heads.
Section 3 - Combustion Air System Exhaust Manifold (3-09)
N14 Page 3-23
To Next Page
Loading...
