Special capscrews with spacers are required for this par-
ticular manifold.
Do not use short capscrews.
Warning: Because this assembly weighs more than 23
kg [50 lbs], two people or a hoist will be required to lift
the exhaust manifold assembly to avoid personal injury.
Install the exhaust manifold and ten capscrews.
Remove the guide studs, and install the remaining two
capscrews.
NOTE: To aid in future capscrew removal, apply a film of
high temperature anti-seize compound to the capscrew
threads.
Tighten the capscrews in the sequence shown to 47 N•m
[35 ft-lb]. Repeat sequence tightening capscrews to 81
N•m [60 ft-lb].
Torque Values: 47 N•m [35 ft-lb]
81 N•m [60 ft-lb]
Install the turbocharger. Refer to Procedure 3-08.
Exhaust Manifold (3-09) Section 3 - Combustion Air System
N14Page 3-24
To Next Page
