CUMMINS N14 - Engine Will Start But Will Not Keep Running

Engine Will Start But Will Not Keep Running
Cause Corrections
----------
• Electronic Fault Code Active
• High Counts of Inactive Fault Codes
OK
f
Refer to N14 CELECT™ System Trouble-
shooting and Repair Manual, Bulletin No.
3810469.
----------
CELECT™ Idle Shutdown Feature Activated
OK
f
Check time limit at idle shutdown with
Compulink™.
----------
Fuel Level in Tank Too Low
OK
f
Add fuel.
----------
Engine Driven Units Engaged (Engine
Starting Under Load)
OK
f
Disengage engine driven units. Refer to
the operation and maintenance manual.
----------
Fuel Filter Plugged or Fuel Waxing
Due to Cold Weather
OK
f
Replace fuel filter. Refer to Procedure 5-01.
----------
Fuel Inlet Restriction Excessive
OK
f
Inspect fuel lines. Refer to Procedure 5-01.
----------
Fuel Contaminated
OK
f
Verify by operating engine from a
temporary supply tank with known good
fuel.
----------
Engine Idle Speed too Low (Below 650
RPM) on PT Fuel System
OK
f
Adjust idle speed. Refer to Procedure 5-05.
(Continued)
SectionT-Troubleshooting Troubleshooting Symptoms Charts
N14 Page T-73