Warning: Do not remove the radiator cap from a hot
engine. Hot steam will cause serious personal injury.
Remove the coolant system pressure cap and close the
shutoff valve before removing the coolant filter. Failure
to do so can cause personal injury from heated coolant
spray.
Remove and discard the coolant filter. Clean the gasket
surface on the filter head.
Installation
Apply a light film of Lubriplate 105 or equivalent, to the
coolant filter gasket sealing surface before installing the
coolant filter.
Install the filter as specified by the manufacturer.
NOTE: Mechanical overtightening can distort the threads or
damage the filter head.
Turn on the shutoff valve and install the coolant system
pressure cap.
Caution: Engine damage will result if the valve is left
closed.
Coolant Filter (1-06) Section 1 - Cooling System
N14Page 1-18
To Next Page
Loading...
