Hold the unloading body down and install the two plain
washers and captive washer capscrews.
Tighten the capscrews.
Torque Value: 14 N•m [10 ft-lb]
Air Compressor (4-07)
Removal
Warning: When using a steam cleaner, wear protective
clothing and safety glasses or a face shield. Hot steam
can cause serious personal injury.
NOTE: The illustrations shown will be of the single cylinder
air compressor. Differences in procedures for one and two
cylinder Holset or Cummins air compressors will be shown
where necessary.
Use steam to clean the air compressor. Dry with com-
pressed air.
Remove the fuel pump. On STC engines, refer to Pro-
cedure 5-02. On CELECT™ engines, refer to the CELECT™
Troubleshooting and Repair Manual, Bulletin No.
3810469.
Drain the engine coolant. Refer to Procedure 1-07.
Remove the coolant lines from the air compressor.
Section 4 - Compressed Air System Air Compressor (4-07)
N14 Page 4-21
To Next Page
Loading...
