Whenever the CELECT™ fuel pump is removed, it is nec-
essary to prime the pump after installing it on the engine
to remove any trapped air.
NOTE: If the fuel pump is dirty, clean the outside of the
pump.
Remove the filter cap from the top of the front support.
Fill the housing with clean fuel. Install and tighten the
filter cap.
Torque Value: 18 N•m [13 ft-lb]
Fill the engine cooling system. Refer to Procedure 1-09.
Operate the engine and check for leaks.
Air Compressor (4-07) Section 4 - Compressed Air System
N14Page 4-24
To Next Page
Loading...
