ST-1013
Water Tester Adapter Plate
Used with hydrostatic tester, Part No. ST-1012.
ST-1022
Valve Spring Compressor Stand
Used to compress all the springs on a cylinder head at the same
time.
ST-1026
Valve Spring Compressor Plate
Used with valve spring compressor stand, Part No. ST-1022.
ST-1134
Dowel Pin Extractor
Used to pull dowell pins.
ST-1173
Fuel Pump Drive Oil Seal Mandrel
Used to drive accessory drive oil seal into the gear cover while
mounted.
ST-1178
Main Bearing Cap Puller
Used to remove the main bearing caps from the cylinder block.
ST-1179
Injector Sleeve Holding Tool (Two each)
Secures the injector sleeve tightly in place in the head when
rolling the upper portion of the sleeve.
ST-1228
Camshaft Bushing Drive Set
Use to replace cylinder block camshaft bushings.
Section 7 - Base Engine Components Base Engine Components Service Tools
N14 Page 7-7
Tool No. Tool Description Tool Illustration
To Next Page
Loading...
