EasyManua.ls Logo

CUMMINS N14 - Engine Power Output Low - Application Specific (Continued)

CUMMINS N14
812 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Engine Power Output Low - Application Specific (Continued)
Genset (Continued)
Cause Corrections
----------
Governor Actuator Malfunctioning
OK
f
Check operation. Refer to the manufac-
turer’s instructions.
----------
Battery Voltage Low (Normally Closed
Governors Only)
OK
f
Check the battery charging system. Refer
to ‘‘Alternator Not Charging or Insufficient
Charging’’ Symptom Chart.
----------
Fuel or Air Delivery Problem
Operate engine at full load. Measure fuel
rate, fuel pressure, and intake manifold
pressure. Refer to Procedure 8-01. Refer to
the Performance Measurement section
following the Application Specific Problems
section.
Marine
Cause Corrections
----------
Governor Break RPM Too Low
OK
f
Adjust idle setting. Refer to Procedure 5-05.
----------
Propeller Damaged or Incorrect (Pitch,
Diameter, or Number of Blades)
OK
f
Check/replace. Refer to the manufactur-
er’s recommendations.
----------
Propeller Shaft Packing Too Tight
OK
f
Refer to the manufacturer’s instructions.
----------
Propeller Shaft Bent
OK
f
Replace shaft. Refer to the manufactur-
er’s instructions.
----------
Hull Dirty or Absorbing Water
OK
f
Clean and check hull. Refer to the
manufacturer’s instructions.
(Continued)
SectionT-Troubleshooting Troubleshooting Symptoms Charts
N14 Page T-49

Table of Contents

Other manuals for CUMMINS N14

Related product manuals