Make a final inspection to make sure all hoses, wires,
linkages, and components have been correctly installed
and tightened.
Warning: Do not remove the radiator cap from a hot
engine. Hot steam can cause serious personal injury.
The engine coolant temperature must be below 70°C
[160°F].
Operate the engine at low idle for 2 to 3 minutes.
Stop the engine and wait 5 to 7 minutes for the oil to drain
to the oil pan. Check the oil and the coolant levels again.
Fill the engine to the correct oil and coolant levels if
necessary. Refer to Procedures 2-07 and 1-09,
respectively.
Operate the engine for 8-10 minutes to check for correct
engine operation, unusual noises, and coolant, fuel or
lubricating oil leaks.
Repair all leaks and component problems. Refer to the
appropriate Sections.
Section 9 - Engine Remove and Install Engine Installation (9-03)
N14 Page 9-11
To Next Page
Loading...
