126 Maintenance AccuVision
®
AV6010 Long-Range Camera System Manual
Accu-Sort Systems, Inc. 07-AV6010_Maintenance_R10.doc
Cleaning the Folding Mirror
WARNING: Shut down the camera system before performing this
maintenance task. Do not stare into the camera’s window at the LED light.
Avoid direct eye exposure. The LED light level does not constitute a health
hazard, however staring at the LED light for prolonged periods could result
in eye damage.
CAUTION: Use care when cleaning the mirror to assure that the
alignment with the camera is not altered. Never apply cleaning solution
directly to the mirror. Always apply the solution to a cloth, and then the cloth
to the mirror. It is a good habit to pre-mark the mirror position, so if it does
move it can be returned to the original position.
This procedure is recommended only if it is noticed that the environment is
dirty enough that deposits are appearing on the folding mirrors. The cleaning
procedure should be performed without removing the mirror from the
mounting structure.
1. Switch off the conveyor.
2. Switch off the camera system.
3. Review the exterior cleaning procedure before cleaning the folding
mirror.
4. Check the folding mirror for any dust, dirt, or smudges.
If the mirror needs to be cleaned, proceed to Step 5.
5. Use a dry, soft, lint-free cloth to remove accumulated dust.
6. If the mirror is particularly dirty or smudged, make a solution of seven
parts denatured alcohol and three parts water. (Many over-the-counter
solutions will leave deposits/smudges that can affect performance.)
7. Apply the cleaning solution to a lint-free cloth.
8. Apply the cloth with the cleaning solution to the folding mirror.
9. Remove any streaks or remaining moisture from the folding mirror with a
dry, soft, lint-free cloth or lens paper.
10. Verify camera operation. Follow the Operations Checklist procedure in
Chapter 6.
To Next Page
Loading...
Need help?
General
