76 Setup AccuVision
®
AV6010 Long-Range Camera System Manual
Accu-Sort Systems, Inc. 05-AV6010_Setup_R10.doc
AV6010 User Interface
System Configuration
Use the System Configuration page to check that a connection is established
with all AV6010 components in your system, assign a name to the system,
and confirm (or set) the positions for each device.
Prerequisites: None.
To set the Name for the system and all camera positions:
1. Select System Configuration from the menu tree.
2. Enter a Name for your system.
3. Click the Blink button to confirm the camera connection and position.
This will cause the illumination to flash on then off again.
(If your application uses multiple cameras, each camera detected by the
system will appear on the screen.)
4. Confirm the Position is properly set for the camera that is flashing it’s
illumination. Change the position using the drop-down menu, if
necessary.
5. Perform Step 4 for every component in the system.
6. Click Update to save any changes.
7. Click Reset to return all parameters to the last values saved.
See also: System Configuration in Appendix B.
To Next Page
Loading...
Need help?
General
