72 Setup AccuVision
®
AV6010 Long-Range Camera System Manual
Accu-Sort Systems, Inc. 05-AV6010_Setup_R10.doc
First-time Startup: Single Camera
1. Make sure all AV6010 system components are connected to the correct
power source.
2. To start the AV6010 camera(s), apply power using the power switch.
3. On initial power-up, the AV6010 performs an initialization sequence.
4. The PWR LED flashes and turns a steady green, followed by TRIG
(green) and TACH (amber). At the same time, the AV6010 illumination
will turn on and remain on for approximately 30 seconds, then turn off.
5. The AV6010 automatically starts all application programs required during
operations.
6. After a few minutes, the illumination flashes ON then OFF.
(The system is ready for operation in approximately five minutes.)
The STAT LED is solid green to indicate normal operation.
NOTE: During the startup sequence, you may proceed with First-Time
Setup and establishing a connection to the AV6010 camera. Do not
attempt a camera connection until the startup sequence is complete.
Status Indicator LEDs
To Next Page
Loading...
Need help?
General
