22 Safety AccuVision
®
AV6010 Long-Range Camera System Manual
Accu-Sort Systems, Inc. 02-AV6010_Safety_R10.doc
Unpacking, Mounting and Installation Recommendations
CAUTION: Firmly fasten mounting structures in place before installing the
equipment to any mounting structure. Avoid using freestanding mounting
structures. If your application requires a freestanding mounting structure,
avoid making the structure top-heavy.
Follow all procedures regarding electrical safety, laser safety, and
electrostatic discharge safety (ESD) as outlined in this manual.
Save all packing material in case you have to transport your AV6010.
Use steel or aluminum as a mounting structure. An Accu-Sort mounting
structure is recommended for optimum system performance.
Check mounting hardware periodically for tightness and stability.
Do not use sheet rock, plaster board, wood, or other unstable mounting
surfaces.
Do not use mounting surfaces that are subject to high vibrations.
Do not create any obstructions of airflow around the equipment. Keep
the area around the equipment clean to provide for cooling. (Refer to
specific product manuals for minimum clearances.)
Avoid dropping the unit(s) during unpacking and installation.
Do not touch the window glass of the RangeFinder, camera or mirror.
Compliance Requirements
FCC NOTICE: The AV6010 Camera has been tested and found to comply
with the limits for a Class A digital device, pursuant to Title 47, Part 15 of the
FCC Rules. These limits are designed to provide a reasonable protection
against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction
manuals, may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at their expense.
WARNING: These are Class A products. In a domestic environment, these
products can cause radio interference, in which case the user may be required
to take adequate measures. (Ref. CISPR 22 = EN 55 022:1995.)
IMPORTANT: Follow the guidelines below to maintain Electromagnetic
Compatibility (EMC) Compliance:
Interconnecting cables must be twisted pair cables.
All shielded I/O cables shall have the shield terminated to the chassis.
NOTE: DRAIN WIRE SHIELDING IS NOT ADEQUATE.
Do not remove the shielding covers.
Refer to the details on making custom cables as provided in the specific
technical manual for the component.
To Next Page
Loading...
Need help?
General
