Datalogic AV500 User Manual

E-GENIUS
188 AV500/AV900 2D CAMERA
DYNAMIC FOCUS MODE
Dynamic Focus Mode (Imaging Calibration Wizard is not available)
Allows the camera to change focus per frame based on data received from a positioning sensor,
usually a DM3610. To determine where to focus the AV500/AV900 dynamically, select one of
the following from the drop-down:
•
Focus to Center Range: Focuses the camera to the center of the range provided by the
positioning sensor.
•
Focus to Average Range: Focuses the camera to the average of the range provided by the
positioning sensor.
•
Focus to Min Range (Near): Focuses the camera to the minimum of the range provided
by the positioning sensor.
•
Focus to Max Range (Far): Focuses the camera to the maximum of the range provided by
the positioning sensor.
Focus Window Size
Enter the value of the Size of the Focus Window.
Focus DOF Threshold
Enter the value of the Depth of Field Threshold. This threshold determines when the camera
will change its position. Once the camera identifies its focus point generated by the position
sensor, it will hold its position until data from the position sensor exceed this threshold.
Use Focus for Label Placement
Select Enabled or Disabled. If enabled, the PackTrack algorithm can use "focus data" from
the Position Sensor to more accurately determine if a decoded symbol can be placed on a
parcel.

Datalogic AV500 Specifications

General

Brand	Datalogic
Model	AV500
Category	Digital Camera
Language	English