degdrive DGI900 - Command Source Selection; Rotation Direction; Maximum Frequency; Frequency Upper Limit

124
If the frequency source is digital setting （P0.01＝0、 1）, the value of P0.02 is the initial
frequency of the AC drive.
P0.03 Command source selection Setting Range：0、 1、 2 0
0：Operation panel control. Using operation keyboard FWD 、 STOP/RESET 、 JOG to
startup/stop.
1：Terminal control. Using external control terminals FWD,REV,X1～X6 to startup/stop.
2 ： Communication control.
Using RS485 communication protocol to
control startup/stop.
P0.04 Rotation direction Setting Range：00～11 0
0：Same direction.
1：Reverse direction.
NOTE: The motor will resume running in the original direction after parameter initialization.
Do not use this function in applications where changing the rotating direction of the motor is
prohibited after system co
mmissioning is complete.
P0.05
Maximum frequency
Setting Range：
50.00Hz～500.0Hz
50.00Hz
When the frequency source is AI, pulse setting (X5), or multi-
reference, 100% of the input corresponds to the value of this
parameter.
P0.06
Frequency upper limit
Setting Range：
P0.07Hz～P0.05Hz
50.00Hz