21：Acceleration/Deceleration prohibited
It enables the AC drive to maintain the current frequency output without being affected by
external signals (except the STOP command).
22：PID pause
PID is invalid temporarily. The AC drive maintains the current frequency output without
supporting PID adjustment of frequency source.
23：PLC status reset
The terminal is used to restore the original status of PLC control for the AC drive when PLC
control is started again after a pause.
24：Swing pause
The AC drive outputs the central frequency, and the swing frequency function pauses.
25：Counter input
This terminal is used to count pulses。
26：Counter reset
This terminal is used to clear the counter status.
27：Length count input
This terminal is used to count the length, for details, see PE.05 and PE.06 description.
28：Length reset
This terminal is used to clear the length (PE.06).
32：Immediate DC braking
To Next Page
Loading...