degdrive DGI900 - Minimum; Frequency Offset of Auxiliary Frequency Source for 1 and 2 Operation; Frequency Reference Resolution; Retentive of Digital Setting Frequency Upon Power Failure

129
4：Switchover between 2 and "1 and 2 operation"
Ten’s digit (1 and 2 operation relationship)
0：1+2
1：1-2
2：Maximum
3：Minimum
P0.20
Frequency offset of auxiliary
frequency source for 1 and 2
operation
Setting Range
0.00Hz～Maximum
frequency
0.00
This parameter is valid only when the frequency source is set to "1 and 2 operation". The
final frequency is obtained by adding the frequency offset set in this parameter to the 1 and
2 operation
results.
P0.21 Frequency reference resolution Setting Range： 1
～2
2
1：0.1Hz；2：0.01Hz；
It is used to set the resolution of all frequency-related parameters.
P0.22
Retentive of digital setting
frequency upon power failure
Setting Range：
0～1
0
This parameter is valid only when the frequency source is digital setting
0 “： Not retentive”： If P0-22 is set to 0, the digital setting frequency value resumes to the
value of P0-02 (Preset frequency) after the AC drive stops. The modification by using keys