control keypad using at the same time, no priority. Both can control the inverter. Hot plug in
for remote control keypad is available.
The following functions are available by using remote control keypad:
(1) Control slave inverter to run, stop, jog run, fault reset, change setting frequency, change
function parameters and running direction.
(2) Monitor slave inverter’s running frequency, setting frequency, output voltage, output
current, bus bar voltage, etc.
2.5.2 Communication cable for remote control panel
Type：DGI900-LAN0020 (2.0m)
Standard options:1m, 2m, 5m, 10m, 20m. Which is more than 20m can be customized for
the remote keypad and inverter connection.
2.5.3 Field bus Adaptor
The inverter can be connected into MODBUS field bus net work via adaptor as a slave
station in the network.
The function as follow:
(1) Send command to inverter such as start, stop, jog running, etc.
(2) Send speed or frequency signal to inverter.
(3) Read status and actual value from inverter.
(4) Fault reset for the inverter.
Please refer to Chapter 9 for communication protocol
To Next Page
Loading...