Chapter 4 Running of Inverter
4.1 Running of Inverter
4.1.1 Running Command Channels
There are three channels for inverter receiving commands like START,STOP, JOG and
others.
Control panel
Use Keys o on the panel to control the inverter.(Factory default )
Control terminal
Use one of terminals amongX1~X7 and COM to constitute a 2-wire control mode.
Serial port
Use upper computer (PC/PLC) or Master inverter to control Slave inverter to start or stop via
serial port.
The command channels can be selected by setting Function Code P0.03, or by
multifunctional input terminal (function code P3.00-P3.09).
Note: These three channels are all switchable. Please make debugging before switch so as
to avoid equipment damage and personal injury.
4.1.2 Frequency setting channel
There are 8 kinds of frequency setting channels as follow:
0: by control panel key, no memory after power off
RUN
STOP
RESET
JOG
▲
▼
To Next Page
Loading...