JOG frequency, for example, by pressing control panel key to give JOG command(refer
to function codeP2.00~P3.02).
1：Close loop running
By setting close loop running control parameter enabled (P0.01=8),the inverter will enter
close loop running, that is PI regulation (refer to function code P6). To make close loop
running invalid, please set multifunctional input terminal (function22)and switch to lower
priority running mode.
2：PLC running
By setting PLC function parameter enabled (P0.01 =7), the inverter will enter PLC running
mode and run according to preset running mode (refer to function code PB).
3：Multi-stage speed running
By setting non-zero combination of multifunctional input terminal (function12,13,14, 15) and
selecting multi-frequency 1-15, the inverter will enter multi-stage speed running mode(refer
to function code PB.00~PB.15).
4：Normal running
Open loop running mode of inverter.
To Next Page
Loading...