If the AC drive is in the stop state, the load speed is the speed
corresponding to the set frequency, namely, "set load speed". If
the set frequency is 50.00 Hz, the load speed in the stop state is
50.00 x 2.000 = 100.00 (display of 2 decimal places).
P7.12
Accumulative power-on time
Setting Range ：
0h～65535h
0h
It is used to display the accumulative power-on time of the AC drive since the delivery.
If the time reaches the set power-on time (P2.16), the terminal
with the digital output function 24 becomes ON.
P7.13
Accumulative power
consumption
Setting Range：
0～65535 kWh
0
It is used to display the accumulative power consumption of the AC drive until now.
6.9 Motor Parameters（Group P8）
P8.00
Motor type selection
0：Common
asynchronous motor
1：Variable frequency
asynchronous motor
0
P8.01
Rated motor power
Setting Range:
0.1KW～1000.0KW
Model
dependent
P8.02
Rated motor voltage
Setting Range: 0～2000V Model
dependent
P8.03
Rated motor current
Setting Range:
0.01A～655.35 A
Model
dependent
P8.04
Rated motor frequency
Setting Range: 0.01HZ to Model
To Next Page
Loading...