degdrive DGI900 - Terminal UP;DOWN Rate; VI Curve 1 Minimum Input; Corresponding Setting of VI Curve 1 Minimum Input; VI Curve 1 Maximum Input

To Next Page

To Previous Page

165

3：Three-line mode 2

SB1：Stop button

SB2：Run button

NOTE ：

When alarm to stop, if running command model chose

terminals valid and FWD/REV is in valid status, reset the fault, the

AC drive will start at once.

P3.15

Terminal UP/DOWN rate

Setting Range：0.001Hz

～65.535

1.000Hz

It is used to adjust the rate of change of frequency when the

frequency is adjusted by means of terminal UP/DOWN.

P3.16 VI curve 1 minimum input Setting Range：

0.00v～P3.18

0.00V

P3.17 Corresponding setting of VI

curve 1 minimum input

Setting Range：

-100.0%～+100.0%

0.0%

P3.18 VI curve 1 maximum input Setting Range： 10.00v

K2Running

direction0Forward1Reverse

FWD

REV

COM

YX9000

SB2

SB1

Figure 6-22 Three-line mode 2