AH500 Module Manual
10-36
RS232
DeviceNet Builder
CPU530-EN
PS05
P 05S
C U530-ENP
10DNET
AH10DNET-5A
Note: The introduction in this section is made in the USB communication method.
2. Open DeviceNet Builder, select “Setup” >> “Communication Setting” and then the following
dialog box appears, where select the driver.
Note: The driver is built via COMMGR software. See section 8.1.4 in the help file of the
DeviceNet Builder software for more.
3. Select “Network” >> “Online” and then the following dialog box appears.
To Next Page
Loading...
