Delta AH500 - Page 442

AH500 Module Manual
11-16
Product picture
Type
Function
CME-DN01
Used for connecting the E series AC motor
drive to the DeviceNet network.
CMC-DN01
Used for connecting the C2000, CH2000,
CP2000 series AC motor drive to the
DeviceNet network.
DN-02
It converts DeviceNet to Modbus gateway
with the DeviceNet interface at one end and
the RS485 port at the other end. It is used
for connecting the AC motor drive to the
DeviceNet network.
DVPDT01-S
Used for connecting the S series PLC CPU
to the DeviceNet network. The module can
be connected to the extension port in the
right side of the S series PLC CPU.
DVPDT02-H2
Used for connecting the DVP-EH2/EH3
series PLC CPU to the DeviceNet network.
The module can be connected to the
extension port in the right side of
DVP-EH2/EH3 series PLC CPU.
TAPCP01
The CAN bus topology tapping box with the
120 ohm resistor enclosed which is
controlled to be effective or not via its
switch.