Delta AH500 - Page 570

AH500 Module Manual
12-34
18. Click “Parameters” item on the left-side window and then set the slave parameters as shown
on the following three interfaces.
Pick “Common” in the following box marked in red and then double click “Hold I/O data” in
order to set the handling of receiving the master data after AH10PFBS-5A is offline.
Name
Setting
Explanation
Loss comm with
master
Hold I/O data
After AH10PFBS-5A is disconnected from the master,
the data that the slave receives from the master will
remain the same as they were before disconnection.
Clear I/O data
After AH10PFBS-5A is disconnected from the master,
the data that the slave receives from the master will be
cleared to 0.