Chapter 12 Network Module AH10PFBM
12-35
Select “<Slot 1> 4 Word Out 4 Word In” in the box marked in red and then double click the
place marked in blue as below so as to set the starting addresses for input and output of the
configured module.
Input mapping
(slave->master)
The initial number of the D
registers in the slave PLC (The
register is for sending data to
the master)
D200
Output mapping
(master->slave)
The initial number for the D
registers in the slave PLC (The
register is for receiving data
that the master transmits).
D300
（Note: the initial D register No. of each configured module must be set up separately.）
To Next Page
Loading...
