Chapter 13 PROFIBUS Slave Module AH10PFBS
13-33
5. And “2 Word Out 2 Word In” has been configured to Slot 0 as follows.
6. Double click where Slot 0 is and the following dialog box emerges.
See the following table on the indications of parameters in the above window.
The number of the starting D register for input and output of the slave which every slot
corresponds to must be set separately. The input D mapping and output D mapping are
defined on basis of the master. E.g. Output represents that master transmits the data to the
slave and input represents that the slave transmits the data to the master.
To Next Page
Loading...
