Chapter 16 Remote I/O Module AHRTU-ETHN-5A
16-15
Name Description
Mode
Mode of getting IP address
Static: Fixed IP address.
DHCP: DHCP server assigns the dynamic IP address.
BOOTP (default): BOOTP server assigns the dynamic IP address.
If DHCP or BOOTP is selected, you can make the setting through IP
manager in EIP Builder.
Set an IP address; default: 192.168.1.3.
Set the IP address for networkmask; default: 255.255.255.0
Set the IP address for gateway; default: 192.168.1.1
Keep Alive Timer
Set the time for keeping connection alive. If the upper machine does not
send the packet to AHRTU-ETHN-5A within the set time, AHRTU-ETHN-5A
will automatically cut the connection with it.
Ethernet - Advance
The tab provides the setting of AHRTU-ETHN-5A’s advanced Ethernet functions including filter and
NTP.
Filter_IP address filter setting
The above page sets the filter function of network devices. Only the devices of which IP addresses
are in the set range are allowed to communicate with AHRTU-ETHN-5A. The packets sent by the
devices of which the IP addresses are out of the set range will be discarded. At most 16 groups of IP
address ranges can be set.
Steps for setting the function:
(1) Select “Enable IP Address Filter” and then double click one line of the following table to open
the IP Address Filter window.
To Next Page
Loading...
