AH500 Module Manual
16-16
(2) Set the range of input addresses in the following window. Note that the start IP address should
be less than the end IP address. Click “OK” after setting is finished.
For instance, after the setting, only the IP address 192.168.1.x (x= 10，11，12，13，14，15，
16，17，18，19，20）is allowed to store in AHRTU-ETHN-5A.
NTP Client Service
Select “Enable NTP Client Service” to connect AHRTU-ETHN-5A to NTP server and set the time
update cycle.
Set the IP address of the network NTP server. Make sure that the
connection to the server is made.
Set the time update cycle for the connection to the NTP server
Set daylight saving time. You can set the start date, end date and time.
To Next Page
Loading...
