Chapter 16 Remote I/O Module AHRTU-ETHN-5A
16-17
(1) Before the network time update is set, select “Enable NTP Client Service” and then set
relevant parameters on the lower part of the following page.
Error handling: Set the mechanism for handling errors in AHRTU-ETHN-5A through the software.
When an error occurs in I/O modules, you can select or not select “Trigger CPU bus
fault when RTU I/O fault”.
When the connection with the CPU fails, you can select “Stop” or “Hold State” for I/O
modules.
When the slave is disconnected, you can select or not select “Trigger CPU bus fault
when RTU is disconnected.”
To Next Page
Loading...
