Digi TransPort WR11 - Page 11

Digi TransPort® Routers User Guide
11
Configuring legacy protocols
About legacy protocols 590
Configure Systems Network Architecture over IP (SNAIP) 591
Forcing SNAIP to use a specific instance 598
Configure TPAD parameters 599
Set TPAD parameters: 604
Configure X.25 parameters 613
Configure general X.25 parameters 614
Configure X.25 LAPB parameters 616
Configure NUI mappings 621
Configure NUA / NUI interface mappings 622
Configure X.25 call macros 625
Configure IP to X.25 call strings 627
Configure Packet Assembler Dissassembler (PADS) 630
Configure an X.25 Permanent Virtual Circuit (PVC) 645
X.25 packet switching 648
Configure a MODBUS gateway 657
Requirements for MODBUS support in TransPort devices 657
Configure the MODBUS gateway 657
Configure MODBUS slaves 659
Configure Protocol Switch software 661
Protocol Switch software logic 663
Configure the Protocol Switch 665
Configure CUD mappings parameters 673
Configure IP sockets to protocol switch 674
Configure NUA to interface mappings 677
Configure NUA mappings 679
Configuring alarms
Configure events to trigger alarms 681
Configure sending email alert messages when events occur 683
Configure SNMP traps 688
Send SMS alert messages when events occur 691
Log events to a secondary log file on an external flash drive 693
Log events to a Syslog server 694
Edit event descriptions 697
Configure event logcodes 699
Configure handling of the reasons for an event 702
Configure an SMTP email account to send alarms 704
Configuring system settings
Set device identity parameters 708
Set system date and time 710
Using NTP is recommended for greater accuracy 710
Set system date and time manually 710
Set system date and time automatically using an SNTPserver 712
Set system date and time automatically using an NTPserver 714
ntpstat command: Check NTP client status 720
Set commands to run automatically at bootup 721
Set web and command line interface options 722
Set miscellaneous system options 725