Digi TransPort WR11 - Use Command Filtering

Configuring security Use command filtering
Digi TransPort® Routers User Guide
810
Use command filtering
When the command filtering feature is enabled, commands will not reach the router’s command
interpreter unless they are defined in the Command Filters table. Terminal devices may send
commands that the router will not necessarily understand but that require a basic OK or ERROR
response.
With command filtering turned on, any command entered will be responded to with a MODEM-like OK
or ERROR response (depending on settings below) unless the command is found in the Command
Filters table. The command filter uses wild-card character matching so that command filters such as
cmd* are permitted which would allow all cmd 0 ... commands to be executed. Note that the
command mapping table is checked first and the command filter table is only checked if there was not
a match in the command matching table.
For more information on command filtering, see Application Note 17: Command Line Response
Manipulation.
É Web
1. Go to Configuration >Security > Command Filters.