Using the command-line interface About the Digi TransPort command line interface
Digi TransPort® Routers User Guide
119
About the Digi TransPort command line interface
Using a Web browser to modify values in the configuration pages is the simplest way to configure the
router. This process is described in the next chapter. However, if you do not have access to a Web
browser, the router can be configured using text commands. You can enter these commands directly
through one of the serial ports or via a Telnet session. Remote configuration is also possible using
Telnet or X.25.
Note Low level permission users are designed to work in the web interface only. Command line use is
not supported for these users.
To Next Page
Loading...
