Digi TransPort WR11 - Configure Internet Key Exchange (IKE)

Configuring Virtual Private Networking (VPN) Configure Internet Protocol security (IPsec)
Digi TransPort® Routers User Guide
500
Configure Internet Key Exchange (IKE)
IKE Debug parameters
ÉWeb
1. Go to Configuration > Network > Virtual Private Networking (VPN) > IPsec > IKE.
The Configuration > Network > Virtual Private Networking (VPN) > IPsec > IKE page
displays configuration pages for Internet Key Exchange (IKE) instances IKE 0 and IKE 1, with a
separate page for IKE Responder. The IKE 0 instance can serve as an IKE initiator or as an IKE
responder, while IKE 1 can serve as an initiator. Use the IKE 0 and IKE 1 pages to set up the
IKE 0 and IKE 1 initiator parameters as required. The IKE Responder page configures the
responder parameters for IKE 0.
2. Configure IKE parameters:
Enable IKE Debug
Enables IKE debugging to be displayed on the debug port.
Debug Level
Sets the level of IKE debugging. The options are:
n Low
n Medium
n High
n Very High
Debug IP Address Filter
Used to filter out IKE packets with particular source or destination IP addresses. The format of
this parameter is a comma-separated list of IP addresses. For example, to exclude the capture
of IKE traffic from IP hosts 10.1.2.3 and 10.2.2.2, enter 10.1.2.3,10.2.2.2 for this parameter.
Conversely, you may wish to only capture traffic to and from particular IP hosts. To do this, use
a tilde (~) symbol before the list of IP addresses. For example, to only capture packets to and
from IP host 192.168.47.1, enter ~192.168.47.1 for this parameter.