Configuring legacy protocols Configure Systems Network Architecture over IP (SNAIP)
Digi TransPort® Routers User Guide
598
Command Instance Parameter Values Equivalent web parameter
snaip x use1sock On, Off, Compatible Use 1 socket.
snaip x inc_mac_exc 1=enabled
0=disabled
Include MAC Exclusivity Capability.
snaip x mac_exc_val 0-1 Mac Exclusivity Value.
snaip x iunsolresp 1=enabled
0=disabled
Ignore unsolicited response frames.
snaip x waitforcontact 1=enabled
0=disabled
Wait for Contact before progressing
to CONNECT PENDING state.
snaip x con_attempts 0-2147483647 Make immediate connection
attempts before backing off
snaip x con_boff_time 0-2147483647 Backoff for x seconds before
attempting to connect again
Forcing SNAIP to use a specific instance
If several SNAIP instances share an ASY port, a switchover to a specific instance can be initiated by
issuing snasw x, where x is the SNAIP instance number. This instance must be available to go online,
or this command will fail.
To revert back and use the default instance, issue the snadis x command. The router uses normal
priorities to determine which SNAIP instance gets to use the SYNC port.
To Next Page
Loading...
