Performing device administration tasks Reboot the router
Digi TransPort® Routers User Guide
941
Reboot the router
You can reboot the router immediately or at a scheduled time.
The router performs a reboot after any FLASH write operations are completed. There is an allowance
of one second each for the following operations to be completed before reboot will occur:
n Create and send IPSec SA delete notifications are created and sent
n Close TCP sockets
n Disconnect PPP interfaces
Note To schedule reboots on a recurring basis, use Digi Remote Manager's device tasks feature and
its schedule options. See the Digi Remote Manager User Guide.
É
Web
1. Go to Administration > Reboot.
2. Enter the reboot options:
Immediately
Causes the router to reboot after a few seconds. The router cleanly terminates any TCP and
VPN connections before rebooting.
In h hrs m mins s secs
Schedules a reboot to occur after the configured period of time. To cancel a scheduled reboot,
enter the reboot cancel command from the command line.
3. Click Reboot to reboot the router or set the scheduled reboot to occur.
Command line
Command Options Equivalent web parameter
reboot n/a Immediately
reboot 0-86400 In h hrs m mins s secs.
This CLI value is entered in minutes only.
reboot cancel
Cancel reboot
To Next Page
Loading...
